Storefront | Search/Shop | Contact Us | FAQ's | My Account | Shopping Cart
Part Number: DTXC3122
$124.95 - 4 in stock
Element 3900kv Brushless ESC and Motor combo package
Extended Product Information:
The Element 3900kV Brushless System is designed specifically for use with lightweight 1/10 scale 2WD off-road vehicles, including buggies, trucks and short course trucks. The programmable ESC and powerful 4-pole motor mount easily; after installation a simple throttle setup is all you need to get going!
The ESC's high level of adjustability allows for fine tuning to enhance performance even more.
The 4-pole, 3900kV sensorless brushless motor delivers more torque with greater efficiency, to meet the demands of today's off-road vehicles.
Dimensions:1.42 x 1.85 in (36 mm x 47 mm)
Weight (w/wires):6.54 oz (185.4 g)
Voltage Input:2S MAX
Shaft Diameter:0.125 in (3.175 mm)
Wires:13AWG Silicone, 6.89 in (175 mm)
Connectors:4 mm Male bullet connectors
Voltage Input:2S-3S LiPo (7.4V-11.1V); 6-10 NiCd/NiMH (7.2V-12V)
BEC:3A @ 2S input
Current Rating:up to 100A
Dimensions:1.81 x 1.38 x 0.79 in (46 mm x 35 mm x 20 mm)
Weight:2 oz (56.5 g)
Motor Wires:13AWG 5.3 in (135 mm), including female bullet connectors
Battery Wires:13AWG 4.72 in (120 mm), with Deans Ultra Plug
Receiver Wire:11.0 in (280 mm), with Universal radio connector
Motor Limit:on 2S/4200kV Max; on 3S/2800kV Max
Protections:low voltage cutoff, thermal protection
ESC Programmable Features*:
Brake/Reverse Type – sets whether reverse is enabled or not, and how it is accessed.
Brake Amount – sets what percentage of available braking power is applied with full brake.
Reverse Amount – sets how much power will be applied in reverse, if reverse is enabled.
Punch/Traction Control – designed to smooth high power starts and limit punch when you don't want 100% battery power in every situation. The lower the setting the less throttle change limiting there is; for softer acceleration or for running on low-grip surfaces, raise it to a higher setting.
Drag Brake – sets the amount of brake applied automatically at neutral throttle to simulate the slight braking effect of a neutral brushed motor while coasting.
Dead Band – lets you adjust the throttle sensitivity width at neutral. Smaller values make the controller enter forward or brake/reverse with a smaller movement of the throttle trigger for finer control.
Cut-Off Voltage – sets the voltage at which the ESC removes power from the motor in order to maintain the battery at a safe minimum voltage (LiPo), or to keep the radio system working reliably (NiCd/NiMH).
Motor Timing – allows for lowering or raising the timing advance to the motor to reduce or increase amp draw, run time, motor/battery temperature and top speed and punch.
*ESC can be programmed manually, with the Castle Field Programming Card or through the Castle Link software interface. (sold separately)
Copyright ©2000-2015 Stormer Hobbies, Inc. All Rights Reserved